IEC 61126 : 1.0

Table of Contents

FOREWORD
INTRODUCTION
SECTION 1: GENERAL
1.1 Scope and object
1.2 Normative references
1.3 General
1.4 Definitions and fundamental considerations
SECTION 2: LAMPS WITH A, G, PS AND SIMILAR BULB SHAPES
2.1 Procedure for use on lamps with A, G, PS and similar
     bulb shapes
2.2 Layout of construction drawing
2.3 Layout of final drawing
SECTION 3: LAMPS WITH PAR AND R BULB SHAPES
3.1 Procedure for use on lamps with PAR and R bulb shapes
3.2 Layout of construction drawing
3.3 Layout of final drawing
SECTION 4: LAMPS WITH C AND SIMILAR BULB SHAPES
4.1 Procedure for use on lamps with C or similar bulb
     shapes
4.2 Layout of construction drawing
4.3 Layout of final drawing
SECTION 6: RIM SUPPORTED INTEGRAL REFLECTOR LAMPS
6.1 Procedure for use on rim supported integral reflector
     lamps
6.2 Layout of construction drawing
6.3 Layout of final drawing
Annex A Alternative procedure for use starting from maximum
        lamp drawing

Abstract

Provides guidelines for the preparation of maximum lamp outlines for the specific bulb shapes and caps noted. Is primarily for the use of lamp standardizing committees.

General Product Information

Published
Document Type	Standard
Status	Current
Publisher	International Electrotechnical Committee
Pages
ISBN
Committee	TC 34