IEC 61319-1 : 1.0

INTERCONNECTIONS OF SATELLITE RECEIVING EQUIPMENT - PART 1: EUROPE

International Electrotechnical Committee

More details

More info

FOREWORD
INTRODUCTION
Clause
1 Scope
2 Normative references
3 Explanation of terms and abbreviations
4 Interface requirements for polarizers and
   polarswitchers
   4.1 Mechanical polarizers (optional)
   4.2 Magnetic polarizers (using the Faraday effect)
        4.2.1 Polarizers for two orthogonal
               polarizations
        4.2.2 Polarizers for four polarizations
   4.3 Polarswitchers
5 Interface requirements for low-noise block converters
   (LNB)
   5.1 Characteristics impedance of the first
        intermediate frequency (IF) OUTPUT
   5.2 Interface between the LNB (outdoor part) and
        satellite receiver (indoor part), case 1: one IF
        input signal and one two-state control command
        5.2.1 Single-band block converters
        5.2.2 Dual-band block converters
        5.2.3 Combination of dual-band block converter
               with polarswitchers
   5.3 Interface between the LNB (outdoor part) and
        satellite receiver (indoor part),
        input signal and internal two-state control command
   5.4 Connectors
6 Interface requirements for switching between different
   antenna sources or antenna positions
   6.1 Electrical matching values for the actuator motor
        supply
   6.2 Electrical matching values for the antenna position
        sensor
   6.3 Interface between the antenna position control unit
        and the satellite receiver
        6.3.1 Circular connector
        6.3.2 Domestic Digital Bus (D2B)
7 Interface requirements for satellite receivers decoders,
   descramblers and conditional access systems
8 Interface requirements for Digital Satellite Radio (DSR)
   receivers
   8.1 Configuration of receiving equipment
        8.1.1 Direct reception of radio only
        8.1.2 Direct reception of radio and television
        8.1.3 Cable reception
   8.2 Audio-frequency outputs of DSR-receivers
ANNEX A Interconnections between a satellite receiver and a
        decoder
Figures

Abstract

Outlines the standardization of interconnections and matching values for satellite receivers for individual television and sound radio broadcast reception in the 10.70 GHz to 12.75 GHz band.