GAGE BLOCKS
American Society of Mechanical Engineers
Foreword<br>Committee Roster <br>Correspondence with the B89 Committee<br>0 Introduction<br>1 Scope<br>2 Normative References<br>3 Definitions<br>4 Nomenclature of Faces<br>5 Basis of Measurement, Traceability, and Reference Condition<br>6 General Dimensions, Material Properties, and Marking<br>7 Metrological Requirements<br>8 Calibration of Gage Blocks<br>Nonmandatory Appendices<br>A - Grade 00<br>B - Differences Between Former GGG-G-15C and This Standard<br>C - Testing Methods<br>D - Possible Sources of Measurement Uncertainty<br>E - Thin Gage Blocks (Less Than 1.0 mm or 0.040 in.)<br>F - Use and Care of Gage Blocks<br>G - Gage Block Sizes and Sets<br>H - Gage Block Accessories<br>I - Gravity and Atmospheric Effects on Gage Blocks
Describes the most important design and metrological characteristics of gage blocks with a rectangular or square cross-section and a nominal length l[n] ranging from 0.5 mm to 1000 mm for metric sizes and 0.010 in. to 40 in. for inch sizes.
| Document Type | Standard |
| Status | Current |
| Publisher | American Society of Mechanical Engineers |
| ProductNote | Reconfirmed 2012 |
