Methods of test for veneer and plywood Measurement of dimensions and shape for sheets of veneer and plywood
Standards Australia
RECONFIRMATION NOTICE
Technical Committee TM-011 has reviewed the content of this publication and in accordance with Standards Australia procedures for reconfirmation, it has been determined that the publication is still valid and does not require change.
Certain documents referenced in the publication may have been amended since the original date of publication. Users are advised to ensure that they are using the latest versions of such documents as appropriate, unless advised otherwise in this Reconfirmation Notice.
Approved for reconfirmation in accordance with Standards Australia procedures for reconfirmation on 27 April 2016.
Approved for reconfirmation in New Zealand on behalf of the Standards Council of New Zealand on 18 May 2016.
The following are represented on Technical Committee TM-011:
Australian Building Codes Board
Australian Forest Products Association
Australian Timber Importers Federation
Australian Wood Panels Association
Building Research Association of New Zealand
Engineered Wood Products Association of Australasia
Forest and Wood Products Australia
Furntech-AFRDI
Glued Laminated Timber Association of Australia
Master Builders Australia
Monash University
New Zealand Plywood Manufacturers Association
New Zealand Timber Industry Federation
Timber Design Society
Wood Processors & Manufacturers Association of New Zealand
This Standard sets out the methods for determining the thickness, length, width, squareness, edge straightness and flatness of veneer and plywood sheets. It applies to whole flat sheets.
| Document Type | Standard |
| Status | Current |
| Publisher | Standards Australia |
| ProductNote | Reconfirmed 07/10/2016. This standard has been reconfirmed in Australia in 2016 and remains current in New Zealand. Reconfirmation Notice 7/10/2016 |
| Committee | TM-008 |
| Supersedes |
|
