Aluminum Alloy, Sheet and Plate, Alclad 4.4Cu - 1.5Mg - 0.60Mn (Alclad 2024-O, Sheet and Plate) Annealed; or when specified, “As Fabricated” (2024-F)
SAE International
RATIONALE
1SCOPE
2APPLICABLE DOCUMENTS
3TECHNICAL REQUIREMENTS
4QUALITY ASSURANCE PROVISIONS
5PREPARATION FOR DELIVERY
6ACKNOWLEDGMENT
7REJECTIONS
8NOTES
1.1 Form This specification covers an aluminum alloy in the form of sheet and plate 0.008 to 1.750 inch (0.203 to 44.450 mm) thick, supplied in the annealed (O) condition (see 8.4). When specified, product shall be supplied in the “as fabricated” (F) temper. 1.2 Application These products have been used typically for formed structural parts which will be subsequently heat treated, but usage is not limited to such applications. 1.2.1 Certain design and processing procedures may cause these products to become susceptible to stress-corrosion cracking after heat treatment; ARP823 recommends practices to minimize such conditions.
| Document Type | Standard |
| Status | Current |
| Publisher | SAE International |
| Committee | AMS D |
