Fixed Capacitors For Use In Electronic Equipment - Part 11: Sectional Specification - Fixed Polyethylene-terephthalate Film Dielectric Metal Foil D.c. Capacitors
Japanese Standards Association
Introduction
Section One - General
1 General
1.1 Scope
1.2 Object
1.3 Normative references
1.4 Information to be given in a detail specification
1.5 Terminology
1.6 Marking
Section Two - Preferred ratings and characteristics
2 Preferred ratings and characteristics
2.1 Preferred characteristics
2.2 Preferred values of ratings
Section Three - Quality assessment procedures
3 Quality assessment procedures
3.1 Primary stage of manufacture
3.2 Structurally similar components
3.3 Certified records of released lots
3.4 Qualification approval
3.5 Quality conformance inspection
Section Four - Test and measurement procedures
4 Test and measurement procedures
4.1 Visual examination and check of dimensions
4.2 Electrical tests
4.3 Robustness of terminations
4.4 Resistance to soldering heat
4.5 Solderability
4.6 Rapid change of temperature
4.7 Vibration
4.8 Bump
4.9 Shock
4.10 Climatic sequence
4.11 Damp heat steady state
4.12 Endurance
4.13 Component solvent resistance
4.14 Solvent resistance of the marking
Related standards
A sectional specification in association with the generic specification JIS C 5101-1, applicable to fixed direct current capacitors, for rated voltages not greater than 6 300 V, with the use of dielectric a polyethylene-terephthalate film and electrodes of thin metal foils. Additional test and requirements may be specified in the detail specification for capacitors with a rated voltage exceeding 1 000 V.
| Document Type | Standard |
| Status | Current |
| Publisher | Japanese Standards Association |
| ProductNote | Supersedes JIS C5113 (06/2002) Supersedes JIS C5101 and JIS C5111 (07/2002) |
| Supersedes |
|
